Send 433 from computer for home automation

[Projectile_Objects]

The flipper is super helpful for capturing various RF frequencies and playing them back. But how can I take the “Read RAW” RF data that the flipper captures and send it out of a Mac or PC for home automation projects?

Example: I have an RF light in the basement. Similar to WIFI switches, I’d like to figure out a way to toggle an on or off TX when I’m not home.

What makes the most sense / is the easiest and most affordable? Arduino board with RF TX?

Please link me to any projects that may cover this. Thanks

[jmr]

If you are set on using the Flipper you want to learn about the Command Line Interface(CLI) but the Flipper isn’t the best device in my opinion. You might want to use it elsewhere and there are more appropriate devices for home automation. I use a Broadlink RMPro and Sonoff RF bridge for 433mHz automation. You could also check out this thread if you don’t mind DIY.

ESP32

Replay RAW on a non-flipper device

Flipper was easily able to record/replay signals from an out-of-production fan remote I have, and I’d like to build a replacement remote, since the original is pretty crappy. I’m planning on rigging an off the shelf CC1101 breakout to an arduino or similar. The one thing that’s unclear is how a stock CC1101 can be fed raw signals – the only library calls I can find send encoded binary data. How does flipper use the CC1101 for raw replay?

CLI

CLI Command Line Interface Examples

CLI = Command Line Interface putty.exe -serial COM3 -sercfg 115200,8,n,1,N Commands to use in serial help storage list / storage list /ext storage read /ext/badusb/demo_macos.txt storage write /ext/badusb/rootjunky.txt paste in file data or type then CTRL + C to close and save. storage remove /ext/badusb/rootjunky.txt loader list power reboot2dfu power reboot power off power debug factory_reset device_info Please Share any CLI examples to help the community