On both 0.50 and 0.51 RC firmware, I cannot seem to run .sub files unless they are directly in the ‘subghz’ folder root. If I try to run a .sub file from a sub-directory folder, it will say that it ran and the vibro will pulse but no signal is actually received from any device. When I put the .sub file back, the file runs correctly. I noticed a similar behavior with .ir files so perhaps this is a more general problem?
did it say somewhere that it should work? all files must be in their places
@SkorP - That’s a fair point that I did not see that sub-directory execution is expressly supported (do you know when the EN documentation might be ready 
?), but it would be a nice feature especially for subghz as that directory can get quite cluttered. Instructions from 3rd party subghz libraries and IR libraries have suggested that other users could run files from sub-directories so I wanted to ask the community about their experience. Thanks!
3 Likes